M-6007-D347SR 347 CUBIC INCHES 415 HP SEALED RACING ENGINE ETA TO BE ANNOUNCED

Ford Sealed Racing Engines are built to professional racing series standards and deliver reliable lasting performance. These aren't built from repackaged production parts, but real racing parts like Forged Crank, Rods and Pistons with full floating piston pins. Each engine is assembled by hand with racing clearances.  Built with the Ford Racing BOSS 302 block these engines deliver reliable and consistent performance lap after lap.

Built for asphalt and dirt circle track racing series that require a sealed racing engine

347 cubic inches - 4.030" bore - 3.400" stroke

BOSS 302 race block

415 hp @ 6000 rpm  400 lb-ft @ 4900 rpm (with headers, and a 650 CFM Holley carburetor not included)

10:1 Compression ratio (nominal)

SCAT® forged crankshaft

SCAT® forged steel cap screw connecting rods

Mahle® forged pistons with floating pins

Hydraulic roller camshaft M-6250-F303, .528'' lift intake and exhaust, duration at .050" is 226 degrees intake and exhaust

Double roller timing chain set M-6268-A302

High-performance 7 quart rear sump circle track oil pan

Ford Racing aluminum "Z" cylinder heads M-6049-Z304DA with 2.02" intake valves and 1.60" exhaust valves

PAC® 1218 ovate beehive valve springs 

1.65:1 ratio roller rocker arms

Edelbrock® Victor Jr. intake manifold M-9424-D302

Edelbrock® Water Pump

SFI approved vibration damper

MSD® billet distributor

ARP® Head Studs

Ford Racing polished aluminum Circle Track valve covers M-6582-CT  

High volume oil pump

Engine is sealed for circle track competition where rules allow

Engine weight as equipped is 431 lbs. (includes 7 quarts of oil)

Additional technical information can be found at www. fordracingparts.com/circletrack

Competes directly with the GMPP® "604" crate engine.

Engine is internally balanced, "0" balance flywheel required

Flywheel is not included INSTALLATION NOTES: See engine installation and tuning tips. Some or all of the following items may need to be changed from your original engine or modified for proper installation:

This engine has a rear sump performance oil pan and pickup, regular rotation timing cover and regular rotation water pump, and non-EFI valve covers. Depending on your application, a different timing cover, water pump, performance oil pan and pickup may be required. See installation notes

Fuel pump eccentric M-6287-B302 installed, allows use of mechanical fuel pump

A standard rotation water pump is installed on the engine. Other applications may require different water pumps and timing chain covers

Damper M-6316-D302, may require a spacer for pulley alignment.

Flywheel M-6375-D302 not included should work for most 157-tooth manual transmission applications. 

Firing order 1-3-7-2-6-5-4-8 (5.0L HO and 351W order).

Built with current available parts.

Photo and specs may vary.

Shipping weight approximately 475 lbs.